Tutorial 2 editorial comments (nitpicking)

[MSoegtropIMC]

Going through tutorial 2 I took the below notes - this is nitpicking level, but I thought you might be interested in this anyway.

Variables:

• typo in screen shot: Disk_pivot instead of Dist_pivot
• it would make sense to take the screens shot showing the first variable "Angle_disk"

Sketch:

• the LCS of the Assembly is called LCS_Origin (in FreeCAD 0.20.1)

Base part:

• it is not obvious how the sketches of the three bodies shall be created (Assembly > Create Sktech or Part Design > Create Sketch) and which support / attachment they should have. Since otherwise you put a lot of attention in the attachment, you might leave a short note here. I created the sketch using the "Part Design > Create Sketch" and used XY plane, which did work.

General comments:
. very useful and to the point tutorial

• I adjusted the heights of the parts right when creating the bodies by adjusting the sketch attachments. I guess this is not the way things should be done, so you might want to mention this when creating the bodies / sketches for the parts.

[Zolko-123]

Good points, I'll try to update the tutorial with your comments ... unless you have some spare time and you could make an update, with screenshots and all ?

[MSoegtropIMC]

I can do the 20.X update. I would change it such that it reflects FreeCAD 20.X only but leave a note in tutorial 1 that things are named differently in older versions.

I have more difficulties saying something intelligent about the sketch creation / attachment, since I don't really know what the differences are. IMHO someone who knows the implementation should leave a few words on this.