ruckus/R730Unleashed #13
giscus[bot]
bot
Replies: 3 comments 3 replies
-
|
Anybody asked for a way to undo this if they want to reconnect it to a ZD or vSZ? |
Beta Was this translation helpful? Give feedback.
-
|
You need to install an older release of Unleashed, use this to get a root shell, then in the root shell set the model and name back to R730, then upgrade to an R730 solo firmware. I can add a guide for this over the Easter break. |
Beta Was this translation helpful? Give feedback.
-
|
Thank you much, I'll give it a shot for now though. wish they would just allow it to be run I know the AP was kinda an oops but still... we have a hundred+ we are about to replace... depending on certain other factors... |
Beta Was this translation helpful? Give feedback.
-
|
Side note I'm really bad at writing, and I tried one AP while I was waiting to see if you would respond, I ended up getting the AP to load the firmware that this article uses at the top, tried to set the BSP back didn't think it worked... tried something else, and then tried to start with what you were saying on the other AP I experimented on, and logged into my ZD and noticed that the first one was sitting waiting to be approved... |
Beta Was this translation helpful? Give feedback.
-
|
So long as you have a ZoneDirector running a release which supports the R850 then I think there should be no ill effects. It's just nice to set it back to R730 in case someone tries to run SmartZone 6.1.1+ or Unleashed 200.15+ or an older ZD release, since these are incompatible. |
Beta Was this translation helpful? Give feedback.
-
|
Yeah, in my case, I still have a couple of R700's on this ZD so I'm as far forward as I can go until I replace those... |
Beta Was this translation helpful? Give feedback.
-
ruckus/R730Unleashed
Hackery
https://ms264556.net/ruckus/R730Unleashed
Beta Was this translation helpful? Give feedback.
All reactions