This library allows an ESP8266/32 module with the HSPI port available to become an AVR In-System Programmer.
The ESP module connects to the AVR target chip via the standard 6-pin AVR "Recommended In-System Programming Interface Connector Layout" as seen in AVR910 among other places.
If the AVR target is powered by a different Vcc than what powers your ESP chip, you must provide voltage level shifting or some other form of buffers. Exposing the pins of ESP to anything larger than 3.6V will damage it.
Connections are as follows:
| ESP | AVR / SPI |
|---|---|
| GPIO12 | MISO |
| GPIO13 | MOSI |
| GPIO14 | SCK |
| any* | RESET |
For RESET use a GPIO other than 0, 2 and 15 (bootselect pins), and apply an external pullup/down so that the target is normally running.
See the included example. In short:
// Create the programmer object
ESP_AVRISP avrprog(PORT, RESET_PIN)
// ... with custom SPI frequency
ESP_AVRISP avrprog(PORT, RESET_PIN, 4e6)
// Check current connection state, but don't perform any actions
AVRISPState_t state = avrprog.update();
// Serve the pending connection, execute STK500 commands
AVRISPState_t state = avrprog.serve();
This library started off from the source of ArduinoISP "sketch" included with the Arduino IDE:
ArduinoISP version 04m3
Copyright (c) 2008-2011 Randall Bohn
If you require a license, see
http://www.opensource.org/licenses/bsd-license.php
Support for TCP on ESP8266/32
Copyright (c) Kiril Zyapkov <kiril@robotev.com>.