This MCC based MPLAB X example shows how to calibrate the gain and offset of the OPAMP when configured as a Programmable Gain Amplifier (PGA). The internal DAC and ADC are used to perform the calibration procedure. No external components are required.

This MCC based MPLAB X IDE example shows how to use the Analog Signal Conditioning (OPAMP) peripheral to implement a constant-current driver using just one external resistor. The constant current amperage setting can be adjusted using firmware control.

This example demonstrates the different OPA peripheral modes of operation. This firmware is pre-loaded onto the Q41 Curiosity Nano development boards.

Operational Amplifier laboratory with the laboratory experiment pdf. A collection of codes, data, and computations.

Perform circuit analysis through hand calculation, then verify the calculation through OrCAD simulation and real-world measurements.

Design of various circuits using operational amplifiers